System Test - Bahco BBT60A Original Instructions Manual

BBT60A
BAD CELL & REPLACE
*The battery has at least one cell short circuit. It should be replaced immediately.
LOAD ERROR
*The tested battery is bigger than 2000CCA/SAE or 200AH. Or the clamps
are not connected properly. Please fully charge the battery and retest after
excluding both previous reasons. If reading is the same, the battery should be
replaced immediately.
14. SOC & SOH Display: Press directional keys to see SOC & SOH:
GOOD & PASS
SOC: xx.xx V
90%
15. Press «ENTER» return to MAIN MENU or remove the test clamps from the
battery posts after completion of testing batteries to end test.

SYSTEM TEST

1. Select "SYSTEM TEST" from the main menu.
2. Turn off all vehicle accessory loads such as light, air conditioning, radio, etc.
Before starting the engine.
3. When the engine is started, one of the three results will be displayed along
with the actual reading measured.
CRANKING VOLTS NORMAL
The system is showing normal draw. Press «ENTER» to perform the charging
system test.
CRANKING VOLTS LOW
The cranking voltage is below normal limits, troubleshoot the starter with
manufacturers recommended procedure.
CRANKING VOLTS NOT DETECTED
The cranking voltage is not detected.
GOOD & PASS
SOH: xxxx CCA/SAE
90%
EN
BAD CELL & REPLACE
VOL: xx.xx V
CCA: xxxx CCA/SAE
IR: xx.xx mΩ
LOAD ERROR
SYSTEM TEST
xx.xx V
TURN OFF LOADS
START ENGINE
CRANKING VOLTS
xx.xx V NORMAL
CRANKING VOLTS
xx.xx V LOW
CRANKING VOLTS
NOT DETECTED