Table of Contents
Advertisement
Hardware Installation
The UniFi AP-Pro can be mounted to the wall or ceiling. Perform
the steps for the appropriate installation:
Wall Mount
1. Position the Mounting Bracket at the desired location on the
wall with the cable feed slot pointed towards the floor.
2. Use a pencil to mark the three holes on the wall. Use a 6 mm
drill bit to drill the holes in the wall.
3. (Optional) If your Ethernet cable feeds through the wall, cut or
drill a circle that is approximately 25 mm in size and lines up
with the cable feed slot.
4. Insert the M3x20 Screw Anchors into the 6 mm holes. Secure the
Mounting Bracket to the wall by inserting the M2.9x20 Screws
into the anchors.
Top
Network Topology Requirements
Optional 25 mm Hole for Ethernet
Cable Feed through Wall
5
Advertisement
Table of Contents
