Kelvinator KSV25HWJ User Manual page 16

SET function
SET
Press the SET button to enter the function setting, then press SET button or TEMP
function. The selected symbol will ash on the display area, press the OK button to con rm.
To cancel the selected function, just perform the same procedures as above.
Press the SET button to scroll through operation functions as follows:
Sleep*( ) Follow Me (
[ * ]: If your remote controller has Sleep button, you can not use the SET button to select Sleep feature.
AP function( ) (some units) :
Choose AP mode to do wireless network
con guration. For some units, it doesn't
work by pressing the SET button. To enter
the AP mode, continuously press the LED
button seven times in 10 seconds.
16
How to Use Advanced Functions
SET
or
) AP Mode ( )
or TEMP button to select the desired
Follow me function( ) :
The FOLLOW ME function enables the remote control to
measure the temperature at its current location and send
this signal to the air conditioner every 3 minutes interval.
When using AUTO, COOL or HEAT modes, measuring
ambient temperature from the remote control(instead of
from the indoor unit itself) will enable the air conditioner
to optimize the temperature around you and ensure
maximum comfort.
NOTE: Press and hold Turbo button for seven seconds to
start/stop memory feature of Follow Me function.
If the memory feature is activated, "On" displays for
3 seconds on the screen.
If the memory feature is stopped, "OFF" displays for
3 seconds on the screen.
While the memory feature is activated, press the
ON/OFF button, shift the mode or power failure will
not cancel the Follow me function.
The design and specifications are subject to change
without prior notice for product improvement. Consult
with the sales agency or manufacturer for details.
OK
CR274-RG10(E)
16117000A3734
3 2021.10.18