ABB UniGear ZS1 Instruction Manual page 28

Figure 37: Handling by means of fork lift trucks
3
4
1
Figure 38
26
4.6.2.3 Handling by means of ABB truck
For handling and inserting the apparatus into the switchgear, use the truck 1 supplied by ABB (Figure
38).
• Do not use the racking in/out truck for any purpose other than handling our apparatus.
• Fix the circuit-breaker to the truck before moving it.
In order to handle the circuit-breaker by means of the relevant truck, follow the instructions below
(figure 38):
• hook the lifting bolts to the circuit-breaker supports and align it above the truck (1):
• press the handles (2) towards the circuit-breaker centre (*) to make the horizontal check pins go in
(3);
• put the circuit-breaker on the truck;
• push the circuit-breaker towards the circuit-breaker compartment and insert the truck into the guides
until the handles (2) are released (**) outwards and the horizontal locking pins go into the slots (4),
locking the circuit-breaker.
3
4
2
(*) Handling direction for horizontal locking pin entry.
(**) Handling direction for exit of the horizontal locking pins.
2
(*)
(**)