ABB UniGear ZS1 Instruction Manual page 12

Figure 4: View into the circuit breaker compartment
10.1 Control wiring socket
12.1 Top shutter
12.2 Lower shutter
14 Earthing switch operating mechanism
14.1 Drive shaft
42 Right-hand travel rail
43.1 Duct cover, top left
43.3 Duct cover, top right
Figure 6: Withdrawable part of VD4 circuit breaker pole side
13.16 Actuating bars
10
In the test/disconnected position, the withdrawable part is still completely inside the panel with the door
closed. The ON/OFF pushbutton located on the circuit-breaker, and the mechanical indicators for ON/
OFF and CHARGED/DISCHARGED can be observed through an inspection window if the circuit
breaker is in service position.
The switching operations are carried out with the doors closed. Installation of an additional mechanical
switching device for manual operation of the circuit-breaker in the service position is also possible (see
fig. 7, 8).
The socket 10.1 (figure 4) for the control wiring is mounted fixed in the circuit-breaker compartment.
13.16
10.1
12.1
43.3
12.2
42
14/14.1
Figure 5: Circuit breaker compartment open
Withdrawable part in disconnected position,
control wiring plug connector open
10.2 Control wiring plug
13.1 Withdrawable part
14 Earthing switch operating mechanism
18.1 Square spigot
10.2
13.1
18.1
14