ABB UniGear ZS1 Instruction Manual page 27

Figure 34: Correct handling
2
Figure 36: Mounting the lifting equipment
4.6.2.1 Handling by means of crane
Circuit Breakers
Hook the lifting bolts to the relevant supports (figure 34). While handling, pay the utmost attention not
to put any stress on the insulating parts and on the circuit-breaker terminals (figure 35).
Before putting into service, remove all the lifting eyebolts.
Contactor
• Insert the lifting bar (1) centring it with the contactor;
• Hook the bracket (2) to the lifting bar (1);
• Hook the bracket (2) by means of a spring catch and lift the contactor;
To remove the lifting equipment proceed in reverse order.
4.6.2.2 Handling by means of fork lift trucks
Do not insert the truck forks straight underneath the apparatus but put the apparatus on a
sturdy support.
Handling by means of fork-lift trucks can be carried out only after the apparatus has been positioned
on a sturdy support.
While handling, pay the utmost attention not to put any stress on the insulating parts and on the circuit-
breaker terminals.
Figure 35: Wrong handling
2
1
25