Table of Contents
Advertisement
Page 42
PC device baud
device: P or M, for Printer or Modem, respectively
baud: 9600 or 19200 for Modem; 1200, 2400, 4800, 9600, and 19200 for Printer; 1200,
2400, 4800, 9600, and 19200 for Aux Data
parity:
O, E, or N, Configurable for Printer or Aux Data devices ONLY. Modem is
always 'N'.
Configures any device other than the Terminal. See Serial Port Section 2.7.7, (Page 30)
for details.
PW (password): One to six alpha-numeric characters.
Changes the modem password to "password".
R type [page]
type: Indicates the type of report as follows:
C
P
G
NC
M
S
ST
SP
[page]: This option can have a value of 1 to 8 and is only applicable for the group
status report. Indicates the page to be reported. If omitted, all eight pages are
reported and scroll off the terminal screen.
SETLNB port LO_freq
Port can be from 1 to 4. (Even if no RF Switch is installed, "1" must be used here.)
LO_freq: This value represents the LNB LO frequency in MHz. It can have up to two
decimal places and its valid range is from 0 to 14000.00.
Sets the assumed LNB LO frequency to the value entered in MHz.
A.1.3
Reports
This section lists the reports generated by the terminal commands, shows the options or origins
of the reports, and gives examples of each report.
800001-01
- Carrier Status
- Parameters
- Group Status
- Network Controller Status
- MPEG
- Settings Status
- Settings Table
- Serial Port Configuration
Page 42 of 56
UNITY500
Advertisement
Table of Contents
