Wegener UNITY500 Manual page 14

Digital video integrated receiver decoder
Hide thumbs Also See for UNITY500:
Table of Contents

Advertisement

Page 14
PARAMETER
Differential Gain
Video Output (Continued)
Differential Phase
Line Time and Field Time
W-form Distortion
Audio Decoder
Compression System
Sample Rates Supported
Unbalanced Audio Output
Output Level Adjust Range
Output Level – MAX PPL
Impedance
Audio Parameters
Frequency Response
Harmonic Distortion (1 kHz
test tone, 1 dB below PPL)
S/N Ratio
Dynamic Range
A/V Sync
Serial Ports
RS-232
Selectable Services
Baud Rates
Formatting
Input Power Rating
LNB DC Power
Voltage
22 kHz tone
Current
Short-circuit protection
800001-01
VALUE
< 3%
< 3 Degrees
< 2% p-p
MPEG-1 Layer 2
44.1 and 48 kHz
Measured at 256 kbps audio PES rate, dual mono mode
0 to –14 dB attenuation from output level shown above
+9.0 +/- 0.5 dBu, 0 dB level, RCA Phono Jack
Unbalanced: < 1000 ohms
20 Hz to 20 kHz, +0.5/-2.0 dB
< 0.5%
< 68 dB (22 Hz to 20 KHz) unweighted
16 Bits
< +/- 50 ms error
RJ12
Auxiliary character-based async output
E-mail character-based async output
Terminal monitoring and control
9.6 kbps and 19.2 kbps
8 data bits; 1 start, 1 stop; half-duplex.
115/230 VAC, 0.8/0.5A, 50/60Hz
Universal LNB supported
14 or 19 VDC, for LNB polarity selection
22 kHz control tone, for LNB DRO selection
250 mA max
Foldback regulator
Page 14 of 56
UNITY500

Advertisement

Table of Contents
loading

Table of Contents