ABB eVM1 Installation And Service Instructions Manual page 101

14.10.1.3 Communication by means of the -XB 58-pin connector and the panel HMI
Connect to the IrDA interface on the panel HMI with the ABB optic cable (RS232/IrDA
converter). Connect the male D-Sub 9-pin connector (of the HMI cable/D-Sub 9-pin for DIN rail)
to the female D-Sub 9-pin connector on DIN rail in the secondary cabinet.
Fig. 89
Indirect PC connection (on RS232 port) / IEC card by means of HMI and D-Sub 9-pin connector
for DIN rail in secondary compartment.
Female D-Sub 9-pin connector
HMI cable / D-Sub 9-pin
for DIN rail
8
1-5
3
Indirect connection to the IED by means of HMI, RS232 / IrDA converter and D-Sub 9-pin
connector for DIN rail in secondary compartment is available only in the Half Duplex version.
1
Male D-Sub 9-pin connector
HMI cable / D-Sub 9-pin
for DIN rail
3
1-5
8
2
3
4
5
Female D-Sub 9-pin
connector for DIN rail
3
1-5
8
1 Panel HMI.
2 ABB optic cable (RS232
/IrDA converter)
3 Female D-Sub 9-pin
connector for DIN rail.
4 Male D-Sub 9-pin con-
nector (of the HMI ca-
ble/D-Sub 9-pin for DIN
rail).
5 Female D-Sub 9-pin
connector for DIN rail.
99