Additional Buttons Of The Pc Mux; Examples; Figure 10: Starting A Multiplexer Session - Siemens TC3 Series User Manual

TC3x Multiplexer User's Guide

5.3 Additional buttons of the PC Mux

In addition to the functions already described the PC Mux has a display and a trace possibility.
With Enable Display/Disable Display the running Mux protocol can be displayed in the status win-
dow. When activating the display before starting the Mux, error messages e.g. for wrong configuration
of the simulation.ini are displayed. Choose Enable/Disable Trace to output results into the file
trace.txt.
Note :
The file may become quite big.

5.4 Examples

Figure 10 shows how to start a multiplexer session. First start the multiplexer simulation by double
clicking on the simulation.exe (1). Then start the terminal programs one after another (2-4). Make sure
that the terminal programs are connected to the correct logical COM Ports. Now enter AT+IPR to set
the baud rate.

Figure 10: Starting a multiplexer session

Afterwards start the multiplexer with AT+CMUX=0 as shown in Figure 11.
TC3x_UG_01_V03.10 - Released Page 19/50 10.01.2002