FocalPoint ATHERSTONE SLATE ELECTRIC SUITE Installation & User's Instructions

FocalPoint ATHERSTONE SLATE ELECTRIC SUITE Installation & User's Instructions

Hide thumbs Also See for ATHERSTONE SLATE ELECTRIC SUITE:

Advertisement

ATHERSTONE SLATE ELECTRIC SUITE
ATHERSTONE BRICK ELECTRIC SUITE
Focal Point Fires Ltd.
RBK House, Irishtown, Athlone,
Co. Westmeath, N37 XP52, Ireland
Tel: 01202 499330
Fax: 01202 499326
www.focalpointfires.co.uk
e: sales@focalpointfires.co.uk
MODELS SHOWN: ATHERSTONE SLATE ELECTRIC SUITE
ATHERSTONE BRICK ELECTRIC SUITE
Revision - A 07/21
2021

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ATHERSTONE SLATE ELECTRIC SUITE and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for FocalPoint ATHERSTONE SLATE ELECTRIC SUITE

  • Page 1 ATHERSTONE BRICK ELECTRIC SUITE Focal Point Fires Ltd. RBK House, Irishtown, Athlone, Co. Westmeath, N37 XP52, Ireland Tel: 01202 499330 Fax: 01202 499326 www.focalpointfires.co.uk e: sales@focalpointfires.co.uk MODELS SHOWN: ATHERSTONE SLATE ELECTRIC SUITE ATHERSTONE BRICK ELECTRIC SUITE Revision - A 07/21 2021...
  • Page 2 2021...
  • Page 3 ATHERSTONE SLATE ELECTRIC ATHERSTONE BRICK ELECTRIC SUITE DS-EHS01-19E SUITE DS-EHS01-20E 36.5kg 24kg H 800 x W 1000 x D 240(mm) H 800 x W 1000 x D 240(mm) ATHERSTONE ELECTRIC SUITE 2021...
  • Page 4 Heater unit Fixing brackets 3x12mm screws Wall plugs 4x30mm screws It should be noted that the appliance creates warm convected air currents.These currents move heat from the room surroundings to, and up the wall surfaces adjacent to the heater. Installing the heater next to these types of wall coverings or operating the heater where impurities in the air ,(such as tobacco smoke) exist, may slightly discolour wall finishing.
  • Page 5 With a pencil mark out the desired height where you STEP1 would like the brackets(A) to be situated on the rear of brackets A 2pcs the legs, to avoid splitting the leg, pre drill the bracket screws B 3x12mm 4pcs holes with a 2mm drill bit.
  • Page 6 Once the brackets are in position, centre and level STEP2 the suite into its final fitting position, mark with a pencil on the wall where you wish to drill. Remove the suite and prepare the wall from the marked positions. If using the fixings supplied, drill a hole in the wall using a 5.5mm drill bit.
  • Page 7: Manual Operation

    LED Display Up Selection Fire ON/OFF Date Time Setting Clear button Timer Set “+” Selection “-” Selection Down Selection Downlights DOWN Open Window/Door detection LIGHT Flame Effect Heat II Heat I Timer ON/OFF NOTE: If the product without downlights function, press the “Downlights” button on the remote control is invalid. NOTE: Before using any operation with the remote control, Insert 2 x AAA batteries to the back of the remote control.
  • Page 8: Safety Cutout System

    Setting the Heat Timer TIMER SET Press the “ ” button on the remote control, the time cycle number will flash. Use the “ ” and “ ” buttons to cycle TIMER SET through the different timer cycles from 1 to 10 and press the “ ”...
  • Page 9 The flame effect does not work 1000 1000 2021...
  • Page 10 This product complies with conformity requirements of the applicable European Regulations or Directives. This product complies with conformity requirements of the applicable UK Regulations. 2021...

This manual is also suitable for:

Atherstone brick electric suite

Table of Contents