16/24
Plug-in switching amplifier VT-SSV | Commissioning
PE
Bosch Rexroth AG, Edition 05.2022, RE 30262-B
8 Commissioning
Uncontrolled plugging and unplugging of connectors!
The device might be destroyed.
▶ Before plugging or unplugging connectors into or from the device, disconnect
the device from the power supply or de-energize it reliably!
Damage to the device caused by incorrect handling is not covered by the
warranty!
▶ Observe the protection class, the voltage supply and the environmental
conditions according to data sheet RE 30262.
For commissioning we recommend using a multimeter.
8.1
BLOCK CIRCUIT DIAGRAM OF THE VT-SSV-1-2X
IN
U+
Abb. 1: Block diagram
1 Connection terminals
– Operating voltage "U+" +24 V
– Enable "IN"
– Operating voltage "GND"
– Equipment grounding conductor "PE"
– Clamping screw M2,6; tightening torque Ma max = 0.4 Nm
2 Electronic switch
3 LED status indicator lamp
4 Electrical connections
9 Operation
Should a fault occur during operation, e.g. a power failure, the VT-SSV-1-2X can
simply be switched on again without requiring further measures and it is then
ready for operation again.
NOTICE
1
U+
IN
GND
PE
2
3
4
2
1
PE