Table of Contents
Advertisement
18/24
Plug-in switching amplifier VT-SSV | Demounting and replacement
Bosch Rexroth AG, Edition 05.2022, RE 30262-B
11 Demounting and
replacement
11.1
REQUIRED TOOLS
For replacement, a screwdriver is necessary.
11.2
PREPARING DEMOUNTING
Risk of injury by demounting parts under pressure and electric voltage!
If you do not de-pressurize and de-energize the system before starting demounting,
you may get injured and the product or system parts may be damaged!
▶ Decommission the entire system as described in the general instructions for
the system.
▶ The system and all connected components must be brought to a safe state. In
addition, the components must be switched off, de-pressurized, de-energized
and secured against restarting.
Decommission the entire system as described in the general instructions for the
system. In any case, bring the system to a safe state, shut it down, depressurize and
disconnect it from the power supply and secure it against being switched on again.
11.3
DEMOUNTING
Electric arc and short-circuit!
Risk of destruction of system components.
▶ Put plug-in connectors down in a way that no short-circuit fault can occur.
Proceed as follows to demount the VT-SSV-1-2X:
1. Loosen the flat head screw and remove the connector.
2. Loosen the plastic cable gland PG11.
3. Open the cover and loosen the clamping screws.
4. Remove the connection cable.
11.4
PREPARING THE COMPONENTS FOR STORAGE OR
FURTHER USE
Proceed as follows in order to prepare electronics from Bosch Rexroth for storage
and further use:
▶ Whenever possible, use the original packaging for storage.
▶ Observe the permissible storage temperature range specified in data sheet RE
30262.
▶ Protect the Product from dust and humidity.
WARNING
NOTICE
Advertisement
Table of Contents
