Table of Contents
Advertisement
Steps
1. Slide the power-supply unit into the chassis until the securing tab snaps into position.
2. Replace the three (#6-32) screws to secure the power-supply unit to the chassis.
3. Route the power cable through the routing guides on the chassis and connect the power cables to their respective
connectors on the system board.
Next steps
1. Install the
side
cover.
2. Follow the procedure in
Processor fan and heat-sink assembly
Removing the processor fan and 125 W heat-sink assembly
Prerequisites
1. Follow the procedure in
WARNING:
The heat sink may become hot during normal operation. Allow sufficient time for the heat sink to
cool before you touch it.
CAUTION:
For maximum cooling of the processor, do not touch the heat transfer areas on the heat sink. The
oils in your skin can reduce the heat transfer capability of the thermal grease.
2. Remove the
side
cover.
About this task
The following images indicate the location of the processor fan and 125 W heat-sink assembly and provide a visual
representation of the removal procedure.
after working inside your
before working inside your
computer.
computer.
Removing and installing components
59
Advertisement
Table of Contents
