Table of Contents
Advertisement
Steps
1. Insert the processor fan into its slot in the heat-sink.
2. Replace the four screws to secure the processor fan to the heat-sink assembly.
Next steps
1. Install the
processor fan and heat-sink
2. Install the
side
cover.
3. Follow the procedure in
Installing the processor fan and 125 W heat-sink assembly
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
NOTE:
If either the processor or the heat sink is replaced, use the thermal grease that is provided in the kit to ensure that
thermal conductivity is achieved.
About this task
The following image indicates the location of the processor fan and 125 W heat-sink and provides a visual representation of the
installation procedure.
Steps
1. Align the screws on the processor fan and heat-sink assembly with the screw holders on the system board and place the
processor fan and heat-sink assembly on the processor.
NOTE:
Ensure that the triangle mark is directed towards the rear side of the computer.
62
Removing and installing components
assembly.
after working inside your
computer.
Advertisement
Table of Contents
