Solid State Relay (Ssr) Replacement - Thermo Scientific CC58114PC Installation And Operation Manual

Maintenance

Solid State Relay (SSR) Replacement

Solid State Relay (SSR) Replacement
To replace the SSR(s), complete the following steps:
1. Remove the control console side panels. The SSR(s) are mounted on the
inside surface of the back panel.
2. Disconnect the wires from the SSR, label the wires for reinstallation.
3. Undo the two screws holding the SSR to the rear panel and remove the SSR.
To install the new SSR, reverse the above procedure.
9-2
Smear a thin layer of heat-sink paste under the new SSR before
fitting.
Thermo Scientific