Up150 Controller Overview - Thermo Scientific CC58114PC Installation And Operation Manual

Operation - UT150 Controller

UP150 Controller Overview

UP150 Controller Overview
This version (V 54 & 56) of the UP150 controller features the dual operation
modes of Single Setpoint and Programming. Each mode has distinct operations
and uses.
Single Setpoint Mode allows the user to select a single target temperature setpoint
in the controller. The controller will then operate the heating equipment until this
setpoint value is achieved.
Programming Mode allows the user to enter a series of setpoint and time
values.The controller will follow these sequences of instructions to energize the
heating equipment until the entire sequence is complete.
The Temperature Controller senses the chamber air temperature of the furnace
(the PV or process value) and supplies the heat necessary to achieve the desired
setpoint. The controller includes an LED display and a push button keypad. Refer
to "Table 1"
6-2
If the process temperature or load changes significantly another
auto tune session may be necessary to optimize the chamber
performance. Recording the values added to "P", "I", Avoid "D"
from previous auto-tune section, would allow these values to be
manually extend using Table 2.
and "Table 2" for lists of displayed parameters and keypad functions.
Table 1. UP150 Parameter Function.
Some changes will have a dramatic affect on the temperature con-
trol in the equipment where this controller is installed.
Thermo Scientific