Programming Operation: Entering A Program - Thermo Scientific CC58114PC Installation And Operation Manual

Operation - UT150 Controller

Programming Operation: Entering a Program

3. Press and release the "SET/ENT" button once to select Local Mode. This
selection causes the red indicator to illuminate beside "L" on the control panel.
refer to
4. Use the "UP" and "DOWN" buttons to select the desired operating temperature
setpoint.
5. Press and release the "SET/ENT" button once to register the setpoint value.
6. The display will then show measured temperature in the upper "PU" display,
the present temperature setpoint in the lower display.
7. This display and the buttons will remain active as long power continues to the
control module. Power interruptions will cause the controller to enter reset or
standby mode in which no actions are made to operate the heating equipment.
You may use the arrow buttons to adjust the setpoint (lower) value to be adjusted
in this local display mode, The "SET/ENT" button will register setpoint value
changes, until these values are changed again.
Exiting Local Mode
To exit Single Setpoint or Local Mode and turn off the energy to the heater:
1. Press and bold for three seconds the "SET/ENT" button to display "modE
LCL".
2. Press and release the "DOWN" button twice to select the display "modE rES".
3. Press and release the "SET/ENT" button once to select the display "modE
rES". Reset Mode.
4. This selection cause the red indicator to extinguish beside display the display
label "L" that bad indicated the Local Mode.
5. This will change the display showing the measured the temperature in the
upper display, with the lower display showing the Start Set Point (SSP)
temperature setpoint of the program.
Programming Operation: Entering a Program
This section describes how to enter a simple program that is designed to:
• Direct the controller to ramp to a higher temperature;
• Stabilize;
• Ramp to a lower-temperature;
• End with an indefinite dwell.
If you intend to use the program features of the controller, it is advisable to go
through all the steps in this sample program to familiarize yourself with the
elements of programming mode.
6-8
"Figure 2. Thermocouple Connection".
Thermo Scientific