Toshiba DeviceNet nv Series Instruction Manual page 116

Chapter 6 Troubleshooting
Table 6-5 Comparison of Module Status Code O: Supported, X: Not supported
Code DN611A Event
0 Normal status
1 Transmission not enabled
2 No data flow in the transmission line
3 Communication error
4 Scan list disagrees with the actual slave
composition.
5 Network error
6 Network power error detected.
9 Busoff is detected.
10 A duplicated node address is detected.
Code Event
70 Detects an error in duplicate node address check.
72 Cannot communicate with slave devices.
73 Vendor ID, product type, and product code of a
slave device differ from those on the DN611B scan
list.
75 No slave device exists on the network. No slave
device is registered on the scan list.
76 DN611B has detected communication timeout due
to no response from slave devices.
77 Slave device transmission size differs from that on
the DN611B scan list.
78 DN611B unable to start transmission to slave
devices.
79 DN611B unable to send to slave devices.
80 DN611B's communication port is in idle mode.
81 DN611B's communication port is in fault mode.
82 Send/receive data fragment error
83 Slave device initialization refused.
84 Slave device initialization not completed.
85 DN611B receive buffer overflow
91 DN611B busoff
92 DN611B network power error
100
6F8C1686
Table 6-6 Comparison of Node Status Detail O: Supported, X: Not supported
DN611B Remarks
O
O
O
O
O
O
O
O
O
DN611B Remarks
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O