Greenscape 750 Food Plotter No Till Drill
Warning: When attaching the Greenscape Food Plotter, Never allow anyone to stand
between the Greenscape Food Plotter and the tractor. Serious injury or death can occur!
Attaching the Greenscape Food Plotter
Back up the tractor to the Greenscape
•
Food Plotter, while lining up the lower
tractor links to the Greenscape Food
Plotter lower pins.
Stop the engine, set the brake and
•
remove the key from the tractor and
block the tractor tires.
Secure the tractor lower arms to the
•
Greenscape Food Plotter lower pins
with lynch pins.
Attach the tractor top link to the
•
Greenscape Food Plotter with the top
link pin and r-clip.
Adjust the tractor sway bars/chains to
•
center the rotary cutter and remove
excess sway.
Adjust lower links and top link so that
•
the Greenscape Food Plotter is level.
Operate the tractor hydraulic controls very slowly up and down. There should be no contact between the
•
Greenscape Food Plotter or any part of the tractor. Failure to check clearance can result in damage to the
Greenscape Food Plotter, tractor (especially the tires) and possible injury to the operator. Maintain no less
than 6" of clearance between the Greenscape Food Plotter, tractor and tractor tires throughout the complete
range of motion.
Operating Instructions
The top link on the tractor hitch should be properly adjusted to carry the machine level in an operating
•
position. During operation the tractor lift must be fully lowered to allow the machine to follow the contour
of the ground.
The machine is totally ground driven, so proceed with a speed that is most comfortable and safe for
•
existing conditions.
Be sure to stop forward motion before lifting machine off ground. This practice will stop rollers from 'free
•
spinning' and therefore eliminate the unwanted application of when turning around.
Never operate the machine in reverse, serious damage will occur!
•
Attaching to Tractor
Tractor Lower Arms
12
Tractor Top Link