Seed Rate Adjustment - Tar River Greenscape 750 Operator's Manual

Greenscape 750 Food Plotter No Till Drill
Large Hopper
To increase the seed rate, turn the knob on the right side of the hopper
clockwise, and lock the jam nuts on hte threaded shaft to assure seeding
accuracy. Refer to the indicator reading on the square seed shaft and find
the corresponding number on the calibration chart to assure you new
rate. Reverse this procedure to decrease rate. Remember to rotate the
seed shaft while adjusting to prevent damage to cups especially if seeds
are in hopper.
Note: When seed cups are fully closed, the indicator should be on 0 (on
the rule). This can be adjusted by simply adjusting the opener as needed.
Fully open would be 1-3/4".
Small Hopper
The seed rate adjustment for the small hopper is located on the left
side of the hopper behind the panel standing at the rear of the
machine. To increase the seed rate, turn the knob on the left side of
the hopper clockwise and then lock the jam nut. Refer to the
indicator reading on the square seed shaft (right side) and find the
corresponding number on the calibration chart to assure your new
rate. Reverse this procedure to decrease rate. Refer to Charts on
pages 16 & 17 of this manual or the rate chart located inside the
hopper lid for the corresponding seeding rate.
Note: When seed cups are fully closed, the indicator should be on 0
(on the rule). Fully open would be 1-1/8".

Seed Rate Adjustment

Warning: LH Cover removed to show detail only.
Never operate implement unless all shields in place!
Serious injury or death can occur.
14
Adjustment Handle
Adjustment Handle