Lubrication And Maintenance - Tar River Greenscape 750 Operator's Manual

Greenscape 750 Food Plotter No Till Drill
Important: It is important to thoroughly clean the seeder after use. Failure to do so can cause irreparable dam-
age to the seed cups and drive system. Grease and turn the Seed adjustment handle to ensure grease lubricates
the threads.
1 Hour Check all fasteners and hardware including set screws in sprockets and bearing collars and re-
tighten as necessary.
8 Hours Grease bearings and inspect chains for tightness.
25 Hours
Remove guard cover on right hand side of machine and inspect chain; lubricate using multi-purpose lithium base
grease.
As needed: Remove any crop residue, grasses, weeds, or debris wrapped around shaft near bearings. This
can cause bearings to overheat and lead to premature failure.
Always:
Protect the machine from weather. NEVER leaver fertilizer in hopper. Do not leave seed in
hopper for more than 24 hours. Remove all fertilizer and seeds from hopper. Thoroughly clean
hoppers and lubricate all drive chains before storage.
Changing Discs
Important: When replacing the discs, it is extremely important to remember
that one of the disc hubs has left hand threads and the other right hand threads.
The threads can be stiped if removed improperly. Left side hub, turn Clockwise
to loosen and turn counter-clockwise to tighten. Right side hub, turn counter-
clockwise to loosen and clockwise to tighten.
Step 1: Remove the dust cap.
Step 2: Remove the external scraper dust cap.
Step 3: Remove hub nuts.
Step 4: Unscrew the hub from the disc support.
Step 5: Replace the discs and reassemble.
Important: When replacing the discs, it is extremely important to remember that
the left disc hub has reverse (LH) threads. The right disc hub has normal (RH)
threads. If turned incorrectly, they can strip.

Lubrication and Maintenance

18