Table of Contents
Advertisement
13.4 Loading the laundry
1. Open the appliance door.
The display shows
2. Shake the items before you put them
in the drum. Put the laundry in the
drum, one item at time.
On the display the weight of the laundry
is updated by steps of kg 0.5 and the
programme duration is updated
accordingly. The weight is indicative and
changes with the type of the laundry.
If you put in the drum more
laundry than the maximum
load, the symbol
flashes for a few seconds
and shows the maximum
recommended load.
You can wash your laundry
anyway, but the water and
energy consumption
increase.
To have the best
consumption and washing
performance remove the
exceeding items.
The overload indication is
shown only in programmes
with a maximum load lower
than the appliance maximum
load.
3. Close the door. Make sure that no
laundry stays between the seal and
the door. There is a risk of water
leakage or damage to the laundry.
4. The display shows the percentage of
detergent quantity needed
This data is indicative and refers to the
detergent dosage recommended for a
maximum load on the detergent
package.
.
.
If you change the washing
programme after closing the
door, the display could show
to indicate a
possible overload: open the
door and remove a few
garments.
13.5 Filling the detergent and
additives
Compartment for prewash phase,
soak programme or stain remover.
Compartment for washing phase.
Compartment for liquid additives
(fabric conditioner, starch).
Maximum level for quantity of liquid
additives.
Flap for powder or liquid detergent.
Always follow the
instructions that you find on
the packaging of the
detergent products, but we
recommend that you do not
exceed the maximum
indicated level (
quantity will however
guarantee the best washing
results.
After a washing cycle, if
necessary, remove any
detergent residue from the
detergent dispenser.
ENGLISH
31
). This
Advertisement
Table of Contents
