Creosote Formation & Removal - HearthStone Clydesdale II 8492 Owner's Manual

C
REOSOTE
R
EMOVAL
When wood burns slowly at low temperatures, it may
produce tar and other organic vapors, which
combine with expelled moisture to form creosote.
These creosote vapors condense in the relatively
cool chimney flue of a slow-burning fire. As a result,
creosote residue accumulates on the flue lining.
When ignited, this creosote makes an extremely hot
fire, which may damage the chimney or even destroy
the house. When burning wood, inspect the chimney
connector and chimney at least once every two
months during the heating season to determine if
there is a creosote buildup.
If a creosote build-up occurs, inspect the stovepipe
connector and chimney more often, at least monthly
during the heating
accumulation. If a creosote residue greater that 1/4"
(6 mm) accumulates, remove it to reduce the risk of a
chimney fire.
Prevention
Burn the stove with the primary air control fully open
for 35 - 45 minutes daily to burn out creosote deposits
from within the stove and the venting system.
After reloading with wood, burn the stove with the
primary air control fully open for 15 to 20 minutes.
This manner of operation ensures early engagement
of the secondary combustion system that minimizes
creosote buildup in the chimney.
If your glass always remains dirty, your operating
temperatures are too low or your wood is wet;
therefore, there is a higher risk of creosote buildup.
Inspect the venting system at the stove connection
and at the chimney top. Cooler surfaces tend to build
creosote deposits faster, so it is important to check
the chimney at the top (where it is coolest) as well as
from the bottom near the stove.
Cleaning
Remove accumulated creosote with a cleaning brush
specifically designed for the type of chimney in use.
We recommend you use a certified chimney sweep to
perform this service. Contact your dealer for the name
of a certified chimney sweep in your area (your dealer
may be a certified sweep!).
We recommend that before each heating season you
have the entire system professionally inspected,
cleaned and repaired, if necessary.
pg. 33
F &
ORMATION
season to monitor
Hearthstone Quality Home Heating Products Clydesdale Model 8492
G
ASKETS
Replace door gasket material every two to three
seasons, or whenever it becomes deteriorated or
loose, depending on stove use. If the door seal leaks,
a new gasket will ensure a tight seal and improve
stove performance.
We recommend
replacement gaskets when you need to replace your
door gasket. Contact your dealer for a gasket kit that
includes instructions, and the gasket for your stove.
Blower System
For maximum efficiency, the blower system will require
periodic cleaning to remove dust that will accumulate during
normal use. To access the blower system, you must remove
the Ash Lip Cover as described in the installation section of
this manual.
the
Remove the Ash Lip Cover and carefully vacuum
components. Take care to avoid bending the fins on the
blower fans. Inspect all wiring and mounting hardware for
damage or deterioration.
1
1. Left Blower Fan Assembly
2. Right Blower Fan Assembly
3. Power Cord
4. Speed Control with Bracket
you only use
3
Hearthstone
2
4