Reset To Factory Default - HMS Anybus Wireless Bolt Serial User Manual

® ™
Anybus Wireless Bolt Serial

9.3. Reset to Factory Default

IMPORTANT
If there is no Ethernet connection available after a factory reset, the Bolt Serial starts in the default
Easy Config Mode 4.
Any one of these actions will restore the unit to factory default settings.
Reset Using the RESET Button
Press and hold RESET for >10 seconds and then release it.
Reset Via the Built-In Web Interface
Launch the built-in web interface > On the System Settings page, click Factory Restore.
Reset Using Easy Config
To reset Bolt Serial to factory default, execute Easy Config Mode 2.
See Activate an Easy Config Mode in the Built-In Web Interface (page
Page 50 of 60
Reset to Factory Default
17).
SCM-1202-143 2.0