Table of Contents
Advertisement
Configuration with AT Commands
5.8.1. Enable Fast Roaming with AT Commands
Fast Roaming is only used for Client Mode.
Fast Roaming is enabled as default but can be permanently disabled using AT commands.
Procedure
Enable or Disable Fast Roaming.
1.
To Enable or Disable Fast Roaming, change the value of register 4004.
• Enable Fast Roaming:
ATS4004=1
• Disable Fast Roaming:
ATS4004=0
2.
For the command to take effect, reboot the Bolt Serial.
Send the Reboot device AT Command:
AT*AMREBOOT
For more information about how to set up WLAN roaming, see the AT Commands Reference Guide or the Help
page in the built-in web interface.
5.8.2. Digital Input
The digital input can be used to control roaming between Bluetooth access points (NAP).
For more information, refer to the AT Commands Reference Guide at www.anybus.com/support.
IMPORTANT
If voltage is applied to the digital input for more that 10 seconds the unit will be reset to factory
defaults.
SCM-1202-143 2.0
®
™
Anybus
Wireless Bolt Serial
Page 19 of 60
Advertisement
Table of Contents
Need help?
Do you have a question about the Anybus Wireless Bolt Serial and is the answer not in the manual?