Palm-Rest And Keyboard Assembly; Removing The Palm-Rest And Keyboard Assembly - Dell Inspiron 14 7425 2-in-1 Service Manual

8. Adhere the tape that secures the I/O-board cable to the system board.
9. Close the right display hinge.
10. Replace the three screws (M2.5x4) that secure the right display hinge to the system board and palm-rest and keyboard
assembly.
11. Align the screw holes on the USB Type-C port bracket with the screw holes on the system board.
12. Replace the two screws (M2x4) that secure the USB Type-C port bracket to the system board.
Next steps
1. Install the fan.
2. Install the heat sink.
3. Install the M.2 2230 solid-state drive
4. Install the wireless card.
5. Install the memory.
6. Install the battery.
7. Install the base cover.
8. Follow the procedure in

Palm-rest and keyboard assembly

Removing the palm-rest and keyboard assembly

Prerequisites
1. Follow the procedure in
2. Remove the base cover.
3. Remove the battery.
4. Remove the coin-cell
5. Remove the memory.
6. Remove the wireless card.
7. Remove the M.2 2230 solid-state drive
8. Remove the I/O board.
9. Remove the speakers.
10. Remove the heat sink.
11. Remove the fan.
12. Remove the power button
13. Remove the display assembly.
14. Remove the system board.
NOTE: The system board can be removed along with the heat sink.
About this task
The following image indicates the location of the palm-rest and keyboard assembly and provides a visual representation of the
removal procedure.
or M.2 2280 solid-state
After working inside your
Before working inside your
battery.
or M.2 2280 solid-state
or power button with fingerprint
drive, whichever applicable.
computer.
computer.
drive, whichever applicable.
reader.
Removing and installing components 49