Steps
1. Align the screw holes on the power-button with the screw holes on the palm-rest and keyboard assembly.
2. Replace the two screws (M2x3) that secure power-button to the palm-rest and keyboard assembly.
Next steps
1. Install the
I/O
board.
2. Install the
display
assembly.
3. Install the fan.
4. Install the
base
cover.
5. Follow the procedure in
Removing the power-button with fingerprint reader
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
3. Remove the
heat
sink.
4. Remove the fan.
5. Remove the
display
assembly.
6. Remove the
I/O
board.
About this task
NOTE:
This procedure is applicable only for computers that are shipped with a fingerprint reader on the power-button.
The following image indicates the location of the power-button with fingerprint reader and provides a visual representation of
the removal procedure.
42
Removing and installing components
After working inside your
Before working inside your
computer.
computer.