Installing The Display Assembly - Dell Inspiron 14 7425 2-in-1 Service Manual

Steps
1. Peel the tape that secures the display-cable connector latch to the system board.
2. Open the latch, and disconnect the display cable from the system board.
3. Remove the two screws (M2.5x4) that secure the left-display hinge to the palm-rest and keyboard assembly.
4. Pry open the left-display hinge at an angle of 90 degrees.
5. Remove the three screws (M2.5x4) that secure the right-display hinge to the palm-rest and keyboard assembly.
6. Pry open the right-display hinge at an angle of 90 degrees.
7. Gently lift the palm-rest and keyboard assembly off the display assembly.
CAUTION: To avoid damaging the display, do not slide the palm-rest and keyboard assembly over the display
assembly.

Installing the display assembly

Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the display assembly and provides a visual representation of the installation
procedure.
Removing and installing components 35