TP-Link TL-WA901ND User Manual page 31

Chapter 4
Note:
To apply any settings you have altered on the page, please click the
the device.
Multi-SSID Mode
• Enable VLAN
you want to configure the Guest and Internal networks on VLAN, the switch you are
using must support VLAN. As a prerequisite step, configure a port on the switch for
handling VLAN tagged packets as described in the IEEE802.1Q standard, and enable
this field.
• SSID (1-4)
filed SSID1 ~ SSID4. The name can be up to 32 characters. The same name (SSID)
must be assigned to all wireless devices in your network. If Enable VLAN is checked,
the wireless stations connecting to SSID of different VLANID can not communicate
with each other.
• VLAN ID (1-4)
device to send packets with VLAN tags. The switch connecting with the device must
support VLAN IEEE802.1Q frames. The wireless stations connecting to the SSID of
a specified VLAN ID can communicate with the PC connecting to the port with the
same VLAN ID on the Switch.
• Channel
change the wireless channel unless you notice interference problems with another
nearby access point.
• Mode
•
•
•
Downloaded from ManualsNet.com
- Check this box and then you can change the VLAN ID of each SSID. If
- Up to four SSIDs for each BSS (Basic Service Set) can be entered in the
- Provide a number between 1 and 4095 for VLAN. This will cause the
- Determines the operating frequency to be used. It is not necessary to
- This field determines the wireless mode which the device works on.
11b only - Only 802.11b wireless stations can connect to the device.
11g only - Only 802.11g wireless stations can connect to the device.
11n only - Only 802.11n wireless stations can connect to the device.
search engine
Configure the Access Point
Save button, and then you will be reminded to reboot
28