Usb Port; Usb Connector Pinnout - Advantech ICR-2701 User Manual

2.3 USB Port

There is one USB 2.0 host port with socket of USB-A type. USB Mass Storages and FTDI
serial converters are supported. For a piece of advice, how to fix an unsupported FTDI chip,
see the Commands and Scripts
The USB port is disabled on overload to prevent its damage (connected device is trying to get
too high current). The port is enabled again after the reboot of the router.
Mounting USB Flash Drive to the System
It is necessary to mount the USB flash drive to be able to access it in the system of the
router. Follow these steps to mount the drive:
Use the dmesg command to see the list of recently connected devices.
In the output of the command find out the entry for the microSD card, for example:
sda: sda1
To mount the card to to mnt directory, use the mount command:
mount /dev/sda1 /mnt
For more information about the commands for creating, mounting, checking and unmounting
a file system on a USB Flash Drive, see the application note for
USB Socket Pinouts
USB socket pinouts is described in Figure
Pin Signal mark
1 +5 V
USB data -
2
3 USB data +
4 GND
application note, chapter How to Use Unsupported FTDI Chip.
4
Figure 4: USB Connector Pinnout
Description
Positive pole of 5 V DC supply voltage, 0.5 A
USB data signal – negative pole
USB data signal – positive pole
Negative pole of DC supply voltage
Table 5: USB Connector Pinnout
14
Ext4_tools
and Table 5.
ICR-2701
router app.
Data flow direction
Input/Output
Input/Output