Heathkit AA-1214 Assembly And Operation Manual page 31

\....I
L
I
L
~
HEATHKIT
~
;h®M'4M
31
d~~
D
O~c~ --
~~
dp
.J-~~-%~
© , - ~
t
~
i ! l l ~ i l i i i l l l ! l l l l i
PICTORIAL 3-8
Hook the end of either black
stranded wire through lug 2 of
switch N and crimp the hook with a
pair of pliers (S-1).
Hook the other black stranded wire
through lug 3 of switch N and crimp
the hook with a pair of pliers (S-1).
Connect the free end of the brown
stranded wire coming from the 4-screw
terminal strip to lug 5 of switch L
( s-
1 ) .
(
)
Connect the free end of the white
stranded wire coming from the
4-screw terminal strip to lug 2 of
switch L (S-1).
Refer to inset drawing No 1 on
Pictorial 3-7 and cut the piece of
fnsulating paper to the indicated
dimensions.
Refer to inset drawing No 2 and
remove the protective paper backing
from the insulating paper. Then
press the paper in place over
switch N.
Refer to Pictorial 3-8 for the following
steps.
Connect the wires from BO No 3 to the
pushbutton switches as follows:
(~ Brown wire to lug 2 of switch [ (S-1).
~
Red wire to l~g 8 of switch E (S-1).
M_
White-viol et wire to 1 ug 2 of switch
F (
S-1).
b-cl
White-red wire to lug 8 of switch F
(S-1).
Connect the wires from BO No 4 to the
amplifier circuit board as follows:
Orange wire to hole W (S-1).
Violet wire to hole X (S-1).
Co~nect the wires from BO No 5 to the
pushbutton switch as follows:
) Yellow wire to lug 3 of switch K (S-1).
/
_ ) Blue wire to lug 6 of switch K (S-1).