Heathkit AA-1214 Assembly And Operation Manual page 26

26
(()
~
HEATHKIT
~
=tM@iH9i-M
~
White-blue wire to lug 1 . (S-l ).
NOTE: Do not connect this wire to
lug 12 by mistake.
(t>(
Yellow wire to lug 2 (S-1).
~
Orange wire to lug 3 (S-1).
(~ White-violet.wire to lug 4 (S-1
1
).
(~ Brown wire to lug 5 (S-1).
N)
Connect the inner lead of the yellow
~
shielded cable .to lug 1~ (S-1). ·
(Nt
Connect the inner lead of the red
:'! ~ .. ,
' - -i !
n
"\ shielded cable to lug _ 6 (S-1 ).
. .
1 - - - - -
PICTORIAL 3-4
Refer to Pictorial 3-4 for the following
steps.
Take the cable assembly and place it
in the chassis as shown. The term
11
B0
11
{breakout) designates a place
where a group of wires come out of
the cable assembly.
Refer to Pictorial 3-5 for the following
steps.
Connect the wires and cables from BO
No 1 to the phono socket assembly as
follows: ·
~
White-green wire to lug 7 (S-1 ).
(~ Blue wire to lug 8 (S-1).
~ Violet wire to lug 9 (S-1).
(~ White-red wire to lug 10 (S-1).
~
Red wire to lug 11 (S-1).
(M'
Connect the shield lead of each of
v\ these shielded cables to the solder
lug (S-2}. Be careful that your
soldering iron does not melt the
insulation on either cable.
Connect the wires and cables from BO
No 2 to the amplifier circuit board
as follows:
(~ Inner lead of the green shielded
cable to hole D . (S-1) and the shield
lead to hole~ (S-1).
(~ J
Inner lead of the red shielded cable
to hole K (S-1) and the shield lead
to hole
J
(S-1).
(~ Inner lead of the yellow shielded
cable to hole L {S-1) and the shield
lead to hole M '(S-1).
(O<_)
White-blue wire to hole N (S-1).
(\ ') White-green wire to hole O ( S-1).
~
(~ Inner lead of the blue shielded
cable to hole H (S-1) and the shield
lead to hole G (S-1).
L
L.
L