Table of Contents
Advertisement
Operation
Custom Color Mixing
To mix a custom color on the Cast Tube, do the following:
1. Press <MODE> repeatedly until Manual Mode shows on the display.
2. Press <ENTER> and one of the following will show on the display:
•
R: _ _ _ (red)
•
G: _ _ _ (green)
•
B: _ _ _ (blue)
•
W: _ _ _ (white)
3. Press <+> or <–> to cycle through the options.
4. Press <ENTER> to select a color.
5. Use <+> or <–> to increase or decrease the selected value, from 000–255.
6. Repeat steps 3 to 5 until the color is set as desired.
7. Press <MODE> to go back to the main menu.
Strobe
To adjust the strobe rate on the Cast Tube, do the following:
1. Press <MODE> repeatedly until Strobe Rate shows on the display.
2. Press <ENTER>.
3. Use <+> or <–> to set the strobe rate, from 000–100.
4. Press <ENTER>.
5. Press <MODE> to go back to the main menu.
Dimmer
To set the dimmer value on the Cast Tube, follow the instructions below:
1. Press <MODE> repeatedly until Master Dimmer shows on the display.
2. Press <ENTER>.
3. Use <+> or <–> to set the dimmer, from 000–255.
4. Press <ENTER>.
5. Press <MODE> to go back to the main menu.
Cast Tube User Manual Rev. 1
Page 7 of 12
Advertisement
Table of Contents
