Mitsubishi Electric MELSEC Q Series User Manual page 57

5)-2 When using a connector for T-branch connection
After removing the sheath by 7cm or more, branch the cable using a connector in the same way as the T-branch connection
method for a dedicated flat cable.
(c) Building T-branch connection
(Trunk line: Dedicated flat cable, branch line: VCTF cable/flexible cable)
6) Branch the cable using a connector in the same way as the T-branch connection method for a dedicated flat cable.
(d) Processing the VCTF cable connector/flexible cable connector (for terminating
resistor)
7) Cut the cover edge at the two roots using
a nipper and remove the edge.
(3) Precautions for use of flexible cables
Prevent an excessive load from being applied to the connector when moving flexible cables.
Downloaded from ManualsNet.com
VCTF cable/flexible cable
connector
VCTF cable/flexible
cable connector
Dedicated flat cable
connector
Cut
search engine
VCTF cable/flexible cable (trunk line)
VCTF cable/flexible cable (branch line)
VCTF
cable/flexible cable
connector
Dedicated flat cable
(trunk line)
8) Place the cover at the point
where the terminating resistor
is to be connected.
CHAPTER 4 PROCEDURE BEFORE OPERATION
VCTF cable/flexible
cable
(branch line)
9) Follow the steps (a) 3) and 4).
4
55