Using The Powerscan™ Pm96Xx; Setting Up The Reader - Datalogic PowerScan Area Imager Quick Reference Manual

USING THE POWERSCAN™ PM96XX
The PowerScan™ PM96XX normally functions by capturing
and decoding codes. Turn on the scanner by pressing the
trigger for 2 seconds. When the scanner starts up, it
vibrates. After the vibration, the trigger can be released
and the startup phase ends.
Table 1 - Aiming System
MODEL
-SRxxxRB
-HPxxxRB
-DHPxxxRB
-DKHPxxxRB
The field of view indicated by the aiming system will be
smaller when the reader is closer to the bar code and
larger when it is farther from the code. Symbologies with
smaller elements (mil size) should be read closer to the
unit. Symbologies with larger elements (mil size) should
be read farther from the unit.
Successful reading is signaled by an audible tone plus a
good-read green spot LED indicator and vibration. Refer-
ence the PowerScan™ 9600 Family Product Reference
Guide (PRG) for more information about this feature and
other programmable settings.

SETTING UP THE READER

Follow the steps below to connect and get your reader up
and communicating with its host.
1. Physically mount the Base station and connect it to
the Host as described in the BC96xx Quick Reference
Guide.
2. Charge the Batteries (see page 4).
3. Link to the Base Station (see page 5).
4. Select the Interface Type (see page 5).
5. Configure the Reader starting on page
depends on settings needed).
Using the PowerScan™ PM96XX
AIMER PATTERN
QUICK REFERENCE GUIDE
13 (optional,
3