Ford EXPLORER Supplemental Owner's Manual page 40

Ready to Drive
(If Equipped)
Illuminates when you switch on
the vehicle and it is ready to
E224090
drive. A corresponding message
may appear stating ready to drive.
Service Engine Soon
It illuminates when you switch
the ignition on prior to engine
start to check the bulb and to
indicate whether your vehicle is ready for
Inspection and Maintenance (I/M) testing.
Normally, it illuminates until the engine is
cranked and automatically turns off if no
system errors are present. However, if after
15 seconds it flashes eight times, this
indicates that your vehicle is not ready for
Inspection and Maintenance (I/M) testing.
If it illuminates when the engine is running
this indicates a system error. The On Board
Diagnostics system has detected an error
in the vehicle emission control system.
If it flashes, engine misfire may be
occurring. Continuing to drive your vehicle
may cause reduced power or the engine
to stop. Failure to respond to the warning
lamp may cause component damage not
covered by the vehicle Warranty. Have
your vehicle checked as soon as possible.
Speed Limiter
Illuminates when you switch on
the speed limiter system.
E172886
Explorer (CTW) Vehicles Built From: 27-09-2021, CG3954en enGBR, Edition date: 202107, First-Printing
Instrument Cluster
Stability Control
E138639
switch the ignition on, this indicates a
system error. During a system error the
system switches off. Have the system
checked by an authorized dealer
immediately.
Stability Control Off
E130458
when you switch the ignition off.
Stop Safely Now
to shutdown or enter into a limited
operating mode. Stop your vehicle as soon
as it is safe to do so. Have your vehicle
checked as soon as possible.
Traffic Sign Recognition Speed
Limit
E181348
If the traffic sign speed warning is enabled,
the light flashes when you have exceeded
the speed limit detected by the traffic sign
recognition system.
Vehicle Plugged in
E228962
attempting to start your vehicle.
37
It flashes when the system is
active. If it remains illuminated
or does not illuminate when you
Illuminates when you switch the
system off. It goes out when you
switch the system back on or
Illuminates if an electrical
component requires service or a
E144693
failure that causes your vehicle
(If Equipped)
Illuminates when the current
speed limit is detected by the
traffic sign recognition system.
Illuminates when your vehicle is
plugged in. A corresponding
message may display after