Sony XC-003 Operating Instructions Manual page 45

The parameters that can be set by the internal switches are as given below.
Switch Function
S1 R/B SYNC
S101 HD/VD sync mode selection
75 termination switch
S102
FLD OUT/DATA IN
S201-1
Interlace / non-interlace
S201-2
WEN pulse phase switch
S201-3
Image output signal phase switch
S201-4
a) Amplitude differs according to external trigger.
For details of switches S201-3 and S201-4, contact your Sony service representative.
Setting
ON If G.SYNC is set to ON, sync signals are added to all RGB signals.
If G.SYNC is set to OFF, sync signals are not added.
OFF Sync signals are not added to the RGB signals.
EXT Uses the external sync signal when input.
INT Resets to internal sync mode. HD/VD signals are output.
The input external sync signal is terminated at 75 on this camera.
ON
OFF The input external sync signal is terminated at 75 on the last
camera connected.
ON The field index is output.
Lets you control the on-screen menu.
OFF
ON Image output signals are scanned without using interlace. You can
continue to output image signals for field 1 only.
Image output signals are scanned using interlace.
OFF
ON Outputs a 1 vertical period amplitude for the image signal period.
OFF Outputs before the image signal.
The image signal is output at 3V from the external trigger.
ON
OFF The image signal is output immediately after the external trigger.
Contents
a)
Default
OFF
EXT
ON
ON
OFF
ON
OFF
49