FNM HPE Series Installation Manual page 46

Prior to the sea trial eliminate the errors with the EDR.
When you first turn the engine control unit it can
have inside
connection/disconnection of devices or sensors
during installation. Always clear any errors before
the first sea trial.
Save with the diagnosis software the following
parameters: RPM, LOAD, ENGINE TEMPERATURE and
COMPRESSOR PRESSURE. Record simultaneously with
an external tool the INTAKE AIR and the DISCHARGE
BACKPRESSURE .
While navigating, move the throttle load until reaching
every point included in the list of the "Sea trial" section,
then specify the parameters recorded by the EDR and by
the other instruments.
42 – FNM® Series HPE – Installation Manual
stored errors due
Also indicate the maximum performance obtained during
the trial.
7. Complete the "Conclusions and approval" part in its
entirety, by inserting the comments in the "Notes" field. In
to the
this phase, it is necessary to:
a. Show the customer all the contents of this
b. Inform them of safety regulations.
c. Explain the use of the engine.
d. Inform the customer about the presence and
e. Inform the customer about the control unit fuses.
f.
g. Inform the customer about his responsibilities.
h. Sign and make the customer sign the document.
When the form is compiled, send it to CMD.
handbook with the engine.
operation of the emergency stop button.
Explain the Limited Warranty terms.
Place the installer stamp on the front part.