Table of Contents
Advertisement
Projection Operations
Manually Selecting the Input Source
The procedure you should use to select the input source depends on whether you are using
projector keys or remote controller keys.
[Projector]
To select the input source using projector keys, press the [INPUT] key on the projector to
cycle through input sources in the sequence shown below.
(RGB/Component)
To select the input source using remote controller keys, press the [RGB/COMPONENT],
[VIDEO], or [S-VIDEO] key on the remote controller to select the input source you want.
The currently selected input source name is shown in the upper right corner of the projection
screen.
If the currently selected input source is not sending an input signal, the message "No
signal input" appears in place of the input source name.
The input source name when RGB/Component is selected as the input source is
displayed as "RGB" or "Component" in accordance with the "Detailed Settings
Advanced Settings 2
see the note under "Auto Input Source Selection" (page 5).
[INPUT] key
(VIDEO)
RGB Input" on the setup menu (page 44). For more information,
6
[S-VIDEO] key
[VIDEO] key
[RGB/COMPONENT] key
[Remote Controller]
(S-VIDEO)
Advertisement
Table of Contents
