Table of Contents
Advertisement
Using the Setup Menu
Using the Password Input Dialog Box
The password input dialog box will appear when any one of the following occurs.
When you turn on the projector while the password is turned on.
When you turn the password on or off.
When you change the password.
When this dialog box is shown, perform a remote controller key operation for each of the
password input positions. The following explains how to input numbers.
The cursor is flashing at the first (leftmost) input position.
The cursor is used to select an input position for input.
Use the remote controller cursor keys to input the password.
Each time you perform a remote controller key operation, " " appears at the current
input position, and the cursor moves to the next input position to the right.
A password can be from one to eight key operations long.
After performing all of the key operations you want, press the [ENTER] key.
To clear your input, press the [ESC] key.
To turn the power on password on and off
1.
Perform steps 1 through 4 under "Basic Setup Menu Operations" on
page 19. Select the "Detailed Settings" main menu, and then select
the "Power On Password" sub-menu item.
2.
Press the [ENTER] key.
This displays a password input dialog box.
3.
Input the current password.
The initial factory default password is: [ ][ ][ ][ ][ ][ ][ ][ ].
For information about how to input the password, see "Using the Password Input
Dialog Box".
4.
Press the [ENTER] key.
If the password you input does not match the currently registered password, the
message "The password you input is wrong". appears. Press the [ENTER] key to
return to step 1.
If the password you input matches the registered password, pressing [ENTER] above
will display the message "The password you input is correct!". Press the [ENTER]
key to advance to the next step.
38
Advertisement
Table of Contents
