Table of Contents
Advertisement
Appendix
Problem
The remote controller
does not work.
The TEMP or LAMP
indicator is flashing or lit.
The message "It is time
to replace the lamp." is
being projected.
The message "The lamp
has exceeded its service
life!." is being projected.
Try performing the following steps, which can return the projector to normal operation.
1. Press the [
2. After the projector's cool down is finished and the fan is completely stopped, unplug
the AC power cord.
3. Plug the power cord back in and turn the projector back on again.
∗ If the power off confirmation message does not appear when you press the [
(power) key, unplug the AC power cord and wait for at least 10 minutes. Then plug
the power cord back in and the projector back on again.
If normal operation does not resume after you perform the above steps, take the
projector to your retailer or authorized CASIO Service Center.
Cause and Recommended Action
The remote controller batteries may be dead.
Replace the batteries (see "Loading Remote
Controller Batteries").
The remote controller may be too far from the
projector.
Make sure the remote controller is within the
allowable range when you operate it.
See "Error Indicators" under "Indicators and
Alert Tones".
It is time to replace the lamp.
Replace the lamp (see "Replacing the Lamp").
The allowable life for the lamp has been
exceeded, and the projector will not turn on.
Replace the lamp (see "Replacing the Lamp").
] (power) key to turn off the projector.
57
See
"User's Guide
(Basic
Operations)"
page 48
"User's Guide
(Basic
Operations)"
"User's Guide
(Basic
Operations)"
"User's Guide
(Basic
Operations)"
]
Advertisement
Table of Contents
