Table of Contents
Advertisement
Using the Setup Menu
IDetailed Settings
This sub-menu specifies the input signal for the projector's VIDEO and S-VIDEO input
terminals.
Input Source Specific Menu Items
Input Source
RGB
Component
S-VIDEO
VIDEO
No Signal
Setting Explanations
Auto:
Other settings: Each setting selects the applicable video system. Use these settings
Setting Storage
This setting is saved for the VIDEO and S-VIDEO input terminals only.
IDetailed Settings
Image Enhancement 2
Image Enhancement 1/Image Enhancement 2 improves the readability of an image following
keystone correction. You should select the Image Enhancement setting (1 or 2) based on
which one produces the desired results, the type of image you are projecting, projection
conditions, etc.
Input Source Specific Menu Items
Input Source
RGB
Component
S-VIDEO
VIDEO
No Signal
Advanced Settings 2
Available Items (Parentheses indicate defaults.)
None
(Auto), NTSC, NTSC4.43, PAL, PAL-M, PAL-N, PAL60, SECAM
(Auto), NTSC, NTSC4.43, PAL, PAL-M, PAL-N, PAL60, SECAM
* Only when the currently selected input source is VIDEO or
S-VIDEO.
Select this setting to have the projector switch the video signal system
automatically in accordance with the input signal from the video device
that is connected to the VIDEO or S-VIDEO input terminal. This is the
setting you should normally use.
when you want to specify only one specific video signal for the VIDEO
and S-VIDEO input terminals.
Advanced Settings 2
Available Items (Parentheses indicate defaults.)
(On), Off
Video Signal, S-Video Signal
Image Enhancement 1/
45
Advertisement
Table of Contents
