Table of Contents
Advertisement
Projection Operations
Auto Input Source Selection
When you turn on the projector, it checks the status of each input source (whether or not
the input source is sending a signal) in the sequence shown below. It automatically selects
the first input source it finds that is sending an input signal, and projects the applicable
image.
RGB terminal input
(RGB/Component)
If the RGB input terminal is connected to a computer and the S-VIDEO input terminal is
connected to a video deck and signals are being supplied by both, for example, the projector
automatically selects RGB input when it is turned on. The currently selected input source
name is shown in the upper right corner of the projection screen.
If the projector does not find any input signal, the message "No signal input" appears in
place of the input source name.
The input source that corresponds to input to the RGB input terminal is displayed in
accordance with the "Detailed Settings
as shown below.
When the setting is "Auto":
When the setting is "RGB":
When the setting is "Component": "Component" is displayed.
Note that the projector does not select the input source automatically when "Off" is
selected for the "Detailed Settings
on the setup menu.
VIDEO terminal input
(VIDEO)
Advanced Settings 2
"RGB" is displayed when the input signal to the RGB
input terminal is RGB, "Component" is displayed in
the case of a component signal.
"RGB" is displayed.
Advanced Settings 1
5
S-VIDEO terminal input
(S-VIDEO)
RGB Input" (page 44)
Auto Input Detect" (page 40)
Advertisement
Table of Contents
