BWI Eagle Air-Eagle XLT Product Information Bulletin

AIR-EAGLE
900MHz RF Transceiver
MODEL 441-40400-DC
DESCRIPTION
The A -E XLT RF T
IR AGLE RANSCEIVER IS
transmit and receive unique signals from one or more transceivers located
up to 2500 feet (or more) away. This model comes equipped with four
contact inputs and four 5amp SPDT relay outputs. This allows the user to
not only transmit information out but receive a confirming signal back that
the operation was performed. The Air-Eagle XLT TRX is user-
programmable for up seven network frequencies to allow multiple systems
to operate simultaneously in the same area and utilizes spread-spectrum
technology to provide the utmost security and reliability even in the
noisiest RF environments. A terminal strip has been provided for
interfacing with external dry contact inputs as well as dry contact relay
outputs. This unit can operate remote machinery such as pumps, gates,
chutes etc.
APPROVALS
United States (FCC)
Canada (IC)
INSTALLATION
DISCONNECT DC Power from all equipment before installation.
1. Mount the A -E XLT TRANSCEIVER in a convenient location.
IR AGLE
2. Select relay options, repeater mode, channel codes and frequency if
desired (see page 2)
3. Install input & output wiring to the terminal strip
4. Install antenna to TNC connector on the right side of the enclosure.
5. Connect DC power to the proper terminals in your control circuit.
TERMINAL STRIP WIRING
INPUTS
1 Common Input 1 9 N/O Relay #1
2 Input 1 10 C Relay #1
3 Common Input 2 11 N/C Relay #1
4 Input 2 12 N/O Relay #2
5 Common Input 3 13 C Relay #2
6 Input 3 14 N/C Relay #2
7 Common Input 4
8 Input 4
DC INPUT
Terminal #1
Terminal #2
All manuals and user guides at all-guides.com
105 Bonnie Drive
Butler, PA 16002
724-283-4681
724-283-5939 (fax)
www.bwieagle.com
XLT
®
a four I/O unit designed to
MCQ-XB900HP
1846A-XB900HP
OUTPUTS
15 N/O Relay #3
16 C Relay #3
17 N/C Relay #3
18 N/O Relay #4
19 C Relay #4
20 N/C Relay #4
(-) 9-36VDC Input
(+) 9-36VDC Input
PRODUCT INFORMATION
BULLETIN
GENERAL OPERATION
Contact closures on inputs 1 thru 4 in the control transceiver transmit
to activate relay #1 thru #4 in the remote transceiver. Inputs from the
remote equipment provide closures to remote transceiver that transmit
to energize relays #1 thru #4 in the control transceiver.
INPUT
ACTION
ACTIVATED
"1"
Transmits channel 1 command to remote unit
"2" Transmits channel 2 command to remote unit
"3" Transmits channel 3 command to remote unit
"4" Transmits channel 4 command to remote unit
INPUT CODE
ACTION
RECEIVED
"1" Relay #1 energizes, maintained momentary
"2" Relay #2 energizes, maintained momentary
"3" Relay #3 energizes, maintained momentary
"4" Relay #4 energizes, maintained momentary