Casio CW-K85 Instructions page 4

3.
Plug the AC adaptor plug into the printer's
AC adapter terminal (1), and then plug the
power cord into a household power outlet (2).
Important!
• Use only the AC adaptor that comes bun-
dled with the printer.
• Take care that you do not excessively bend
or twist, or pull on either end of the power
cord (points marked A and B in the illus-
tration). Take care that the power cord is
not bent excessively at these points when
storing the cord. Any of the conditions
mentioned above can cause breaks in the
wiring of the cord.
4.
Connect the USB cable to the USB port of
the printer.
■ For a model that comes with batteries
1.
Turn over the printer and remove the battery
cover.
• Never bend or twist the battery cover, or
otherwise subject it to rough handling.
Doing so creates the risk of printer
malfunction.
2.
Load a set of eight batteries.
• Make sure the positive g and negative
h poles of the batteries are facing in the
proper directions.
3.
Replace the battery cover.
4.
Connect the USB cable to the USB port of
your computer.
Important!
• Be sure you connect directly to the USB
port of the computer. Connecting through
a hub or chaining through another USB
device may cause misoperation.
• The first time you connect the USB cable,
you have to remove the sticker covering
the printer's USB port.
5.
Connect the USB cable to the USB port of
the printer.
Installing the USB Driver
After installing the bundled software, connect the CW-K85 to your computer,
and then press the COMPUTER LINK button. This will start the USB driver
installation wizard. Follow the instructions that appear on the display to install
the USB driver.
• If you are running Windows XP, the message
shown nearby will appear during USB driver
installation. When it does, click Continue
Anyway to proceed with the installation.
• If you are running Windows 2000, the "Digital
Signature Not Found" error message may
appear during USB driver installation. If it
does, click Yes to proceed with the
installation.
• The above messages do not appear on a
system running Windows ME, 98SE, or 98.
2
1
B
A
Disconnecting from a Computer
Important!
• Never disconnect the AC adaptor, power cord, or USB cable while a print
operation is in progress. Doing so creates the risk of printer malfunction.
• Never disconnect the AC adaptor or remove the batteries while the printer is
turned on. Also, make sure that the display is completely blank after turning off
the printer before disconnecting the AC adaptor or removing the batteries.
Disconnecting the AC adaptor or removing the batteries at the wrong time can
cause loss of text you are working on, as well as data you have stored in printer
memory.
• Never touch the USB cable plugs or AC adaptor plug while a data
communication operation is in progress.Static electricity from your fingers can
cause data communication to be terminated.
1.
Unplug the USB cable from the computer and printer.
2.
Unplug the power cord from the wall outlet (1), and then unplug the AC adaptor
from the printer (2).
• Step 2 is not required if you are not using the AC adaptor.
2
1