ABB ACS880 Manual page 437

No. Name / Range /
Selection
Torque
Speed
Frequency
Position
58.29 EFB act2 type
Auto
Transparent
General
Torque
Speed
Frequency
Position
58.30 EFB status word
transparent source
Not selected
Other
58.31 EFB act1 transparent
source
Not selected
Other
58.32 EFB act2 transparent
source
Not selected
Other
58.33 Addressing mode
Description
1.10 Motor torque is sent as actual value 1. The scaling is
defined by parameter 46.3 Torque
1.1 Motor speed used is sent as actual value 1. The scaling
is defined by parameter
1.6 Output frequency is sent as actual value 1. The scaling
is defined by parameter
Motor position is sent as actual value 1. See parameter
90.6 Motor position scaled.
Selects the type/source and scaling of actual value 2
transmitted to the fieldbus network through the embedded
fieldbus interface.
Type/source and scaling follow the type of reference 2
selected by parameter 58.27 EFB ref2
individual settings below for the sources and scalings.
The value selected by parameter
transparent source is sent as actual value 2. No scaling is
applied (the 16- bit scaling is 1 = 1 unit).
The value selected by parameter
transparent source is sent as actual value 2 with a 16-bit
scaling of 100 = 1 unit (ie. integer and two decimals).
1.10 Motor torque is sent as actual value 2. The scaling is
defined by parameter 46.3 Torque
1.1 Motor speed used is sent as actual value 2. The scaling
is defined by parameter
1.6 Output frequency is sent as actual value 2. The scaling
is defined by parameter
Motor position is sent as actual value 2. See parameter
90.6 Motor position scaled.
Selects the source of the status word when
profile is set to Transparent.
None.
See Terms and abbreviations (page
Selects the source of actual value 1 when
type is set to Transparent
None.
See Terms and abbreviations (page
Selects the source of actual value 1 when
type is set to Transparent
None.
See Terms and abbreviations (page
Defines the mapping between parameters and holding
registers in the 400101...465535 Modbus register range.
Changes to this parameter take effect after the control unit
is rebooted or the new settings validated by parameter
58.6 Communication control.
scaling.
46.1 Speed scaling.
46.2 Frequency scaling.
type. See the
58.32 EFB act2
58.32 EFB act2
scaling.
46.1 Speed scaling.
46.2 Frequency scaling.
58.25 Control
132).
58.28 EFB act1
or General.
132).
58.29 EFB act2
or General.
132).
Parameters 437
Def / Type
FbEq 16b / 32b
3
4
5
6
Torque / uint16
0
1
2
3
4
5
6
Not selected / uint32
0
Not selected / uint32
0
Not selected / uint32
0
Mode 0 / uint16