Getting Started: Assembly - Shark VAC-THEN-STEAM MV2010WM Owner's Manual

Getting Started: Assembly

When assembling your Vac-Then-Steam
there may be a little water in or around
the water tank. This is because we
quality test all our Shark products before
distributing them, so you get a quality
Shark ® Vac-Then-Steam.
a
c
d
e
f
g
b
a
Telescopic Handle
b Cleaning Unit with Dust Cup
c Micro-fiber Steam Pads
d Steam Frame
e Storage Tray
f
Filling Flask
g Replacement Post-Motor Filter(1)
h Replacement Dust Cup Filters(2)
2 TOLL FREE: 1-800-798-7398
i
j
k
l
m
n
o
p
h
i
Mop Handle
j Quick Release Swivel Cord Wrap
k Cord Clips
l Telescopic Handle Latch
m Carry Grip
n
Vacuum and Steam Mode Panel
o Water Tank Cap
p Water Tank Viewing Window
q Dust Cup
1
q
ASSEMBLY
1 Slide the Telescopic Handle into the
cleaning unit until it locks into place.
Once in position, you never have to
remove the wand.
2 For your comfort, you can adjust the
height of the handle. To do so lift the
latch on the tube 90 degrees to the
open position. Holding the handle,
extend the tube to the height that is
right for you and then close latch to
lock the position.
3
2
3
Wrap cord around cord holders and
secure plug to cord.
NOTE: The Vac-Then-Steam, is a
complete bare-floor cleaning and
sanitizing system. It comes "vacuum-
ready" out of the box.
QUICK TIP: For easier pushing and
pulling, extend the height of the
handle by rasing the telescopic latch
on the poll.
English
www.sharkclean.com 3