Shark VAC-THEN-STEAM MV2010WM Owner's Manual page 8

Getting Started: Steam Mode
1
2
STEAM CLEANING
1 Plug in the cleaning unit. Slide
the toggle switch to expose the
Steam Power button.
2
Press the Steam Power button to the
ON position. The illuminated red light
indicates that the "boiler" is on. Wait
30 seconds for the water to heat up
and be steam ready.
10 TOLL FREE: 1-800-798-7398
3
3
Place your foot lightly on the top of
the base. TILT HANDLE BACK TO
ACTIVATE STEAM PUMP.
4. Push handle upright to stop steam
NOTE: Check water level and fill
anytime throughout the cleaning
process, to maintain optimal steam.
2
1
STORAGE
1 Turn the unit OFF. Press your foot on
the Steam Frame.
2 When cool enough to handle,
separate Steam Pad from Steam
Frame.
3 Remove tethered water tank cap. Lift
cleaning unit over sink and empty
water. Replace water tank cap.
CAUTION: Use caution When
handling the Steam Frame. Magnetic
connections on the frame retain heat.
3
4
4
Wrap cord securely around cord
management hooks.
5 Store your Vac-Then-Steam in the
storage tray
IMPORTANT: Do not store cleaning
system with water in the tank or an
attached, damp pad.
www.sharkclean.com
English
11