Related Manuals for Shark VAC-THEN-STEAM MV2010WC
Summary of Contents for Shark VAC-THEN-STEAM MV2010WC
- Page 1 www.SharkVacThenSteam.com VAC-THEN-STEAM™ MV2010WC OWNER’S GUIDE MV2010WC_11_IB_ENG_100803.indd 1 04/08/10 9:37 AM...
-
Page 2: Important Safety Instructions
27. DO NOT store unit with damp/wet the floor manufacturer. micro-fiber cleaning pad attached. POLARIZED PLUG: 28. DO NOT use the vacuum cleaner TO REDUCE THE RISK OF ELECTRIC without dust cup and filter in place. SHOCK, this appliance has a polarized 29. -
Page 3: Table Of Contents
Only this method creates and delivers 212°F steam that is effective enough to clean and sanitize all your hard floor surfaces. The Shark ® Vac-Then-Steam™ can help you achieve a truly clean and healthy environment for you and your family. -
Page 4: Shark ® Vac-Then-Steam
Getting Started: Assembly When assembling your Vac-Then-Steam™ there may be a little water in or around the water tank. This is because we quality test all our Shark products before distributing them, so you get a quality Shark Vac-Then-Steam™. ®... -
Page 5: Vacuum Mode
Getting Started: Vacuum and Steam Panel The Vac-Then-Steam™ has two operating modes: VACUUM MODE: DO NOT USE STEAM PAD AND FRAME IN VACUUM MODE OPERATING IN STEAM MODE: Attach steam pad and frame. Steam mode will not work if the pad and frame are NOT attached. - Page 6 Vacuum Mode STORAGE Place your foot lightly on the top of the base. Tilt cleaning unit into the upright position. Turn off the vacuum power button and unplug the unit. Wrap cord around cord holders and secure plug. Store cleaning unit in an upright position.
-
Page 7: Steam Mode
Steam Mode MAGNETIC CONNECTIONS ASSEMBLY Place the cleaning unit onto the Attach a steam pad onto the bottom Steam Frame. THE UNIT MUST BE of the steam frame, matching the UPRIGHT. hook and loop fasteners. IMPORTANT: Steam frame and pad Place the steam frame/pad assembly must be attached to the cleaning unit on the floor with the magnetic... - Page 8 Steam Mode STEAM CLEANING Place your foot lightly on the top of Plug in the cleaning unit. Slide the base. TILT HANDLE BACK TO the toggle switch to expose the ACTIVATE STEAM PUMP. steam power button. Push handle upright to stop steam. Press the steam power button to the ON “I”...
-
Page 9: Maintaining Your Vac-Then-Steam
Use one of the replacement filter sets when another set is drying. POST-MOTOR FILTER Twist the Shark post-motor cover counter-clockwise to release cover. Use both hands to grip cover on both sides and pull cover toward you. -
Page 10: Troubleshooting Guide
OWNERSHIP REGISTRATION CARD FOR CANADIAN CONSUMERS ONLY Please complete and return or call 1-800-798-7398 to register your new Shark within ten (10) days of purchase . The registration will enable us to contact you in the event a product defect is discovered. By returning this card you acknowledge to have read and understood the instructions for use, and warnings set forth in the accompanying instructions. -
Page 11: Www.sharkvacthensteam.com
Euro-Pro Operating LLC Newton, MA 02459 CAN: Ville St-Laurent, QC H4S 1A7 1-800-798-7398 www.SharkVacThenSteam.com Copyright © 2010 Euro-Pro Operating LLC Printed in China Illustrations may differ from actual product. MV2010WC.E.100803 MV2010WC_11_IB_ENG_100803.indd 16 04/08/10 9:38 AM...